号数 ばね論文集30号(1985年)
ページ数 pp.33-43
種類 論文
論文名 2本コイリングにおける工具配置と製品形状(平面巻きの場合)
Title Positioning of Coiling Tool in 2-Fingers System
著者 対馬 一憲・久納 孝彦・河合 通文・北川 元洋・辻岡 康・水野 正夫
Author Kazunori TSUSHIMA・Takahiko KUNOH・Michifumi KAWAI・Motohiro KITAGAWA Yasushi TSUJIOKA・Masao MIZUNO
抄録 本論文では、2本ピン方式コイリングマシンによるコイルばねの冷間成形法における工具配置と製品形状との関係について記述している。
 それらの結果を要約すると以下の通りである。
1) 圧縮コイルばねの成形中の形状曲線を二つの円孤で近似したモデルを仮定すると、解析結果と実験結果とが良く一致する。
2) 成形コイルの中心位置を水平方向にずらさず,常に切断の刃の作動線上に定めるためには、2本のコイリングピンの変位の比を一定に保てば良い。
3) 線とコイリングピンとの接点は、ピンを移動させるにつれて、一定方向に移動する。従って、適切にピンを作用させるには、ピンを鉛直線に対して一定の角度をもって移動させることが望ましい。
Abstract In this paper, we describe an experimental study of positioning of coiling tool in cold working method of helical springs in 2-figers system. The summary of the experimental results are shown as follows.
(l) Experimental results agree well with the theoretical results on the assumption that the wire forming curve of the shape of helical compression springs during coiling consists of two circular arcs.
(2) Ratio of displacement in two fingers should be kept constantly in order to keep central position of formed springs on the acting line of cutting blade.
(3) It is found that contact points between wire and fingers move to a constant direction. Therefore position of two fingers should be hold on the line with a constant angle to a vertical line.
担当者の所属 慶應義塾大学理工学部
Belonging Faculty of Science and Technology Keio University
Key Words