号数 ばね論文集36号(1991年)
ページ数 pp.1-4
種類 論文
論文名 高強度非磁性17Cr-15Mn-0.35Nステンレス鋼の諸性質
Title Properties of High Strength, Non Magnetic, Austenitic 17%Cr-15%Mn-0.35%N Stainless Steel.
著者 関口 力・芳賀 稔・新井 宏
Author Tsutomu SEKIGUCHI・Minoru HAGA・Hiroshi ARAI
抄録 高Mnオーステナイト系である17Cr-15Mn-0.35Nステンレス鋼の諸性質を、ばね材への応用の立場から調査し、C-Ni系の301, 304その他等と比較検討した結果、以下のことが分かった。高Mnのため多量のN添加が可能で、高Cと共に高Nとすることによる固溶強化と、これらオーステナイトフォーマーの多量添加に基づく組織安定化により、高強度および完全非磁性となる。冷間加工材の低温焼鈍による強度上昇はCr-Ni系301より大きく、また軟化開始温度もこれより200゜C程度高温側の650〜700゜C付近にある。またこの温度範囲では過時効(長時間加熱)による強度低下も非常に緩慢である。短時間引張試験により常温から800゜C間の高温強度を測定したところ、いずれのCr-Ni系ステンレス鋼、耐熱鋼よりも大であった。以上からこの材料は高強度、非磁性ばね材の他、例えば自動車エンジンガスケットのような耐熱ばね用途にも期待がもたれると考えられる。
Abstract Properties of 17%Cr-15%Mn-0.35%N austenitic stainless steel were investigated for its application to spring use, compared with other Cr-Ni type 301, 304 and so on. 
 This stainless steel has high strength and maintains its low magnetic permeability even after large amounts of cold working. Increasing of the hardness and the threshold value of spring by aging of this steel in the as rolled condition is larger and its softening start temperature is 650 to 700゜C, about 200゜C higher than those of type 301 steel. Decreasing rate of its hardness by so high temperature overaging as 700 to 800゜C is very slow. The elevated temperature strength of this steel by short time tensile test was compared wit the other Cr-Ni stainless and heat resistant steels ; type 304, 310 and so on. This steel has the highest strength at the temperature range of RT t 800゜C among these steels. 
 This stainless steel is used where high strength and low magnetic permeability are required. And also this steel is expected to be used for elevated temperature spring such as metal packing for automotive engine peripheries : cylinder head gasket, exhaustmanifold gasket, and so on.
著者の所属 日本金属工業(株) 研究開発部 研究部
Belonging Research and Development Headquarters, Nippon Metal Industry Co., Ltd.
Key Words